Low voltage installation covers a wide range of scope, from one camera on a back entrance to a building's entire security and network infrastructure on a construction schedule. What stays constant is the standard: installed to spec, routed cleanly, tested before handover, and documented so the work can be serviced by somebody who was not there the day it went in.
We take on new construction, tenant improvements, remodels, and upgrades to systems already in service. Scope gets quoted straight, and the licensed contractor is on site doing the work rather than dispatching it and hoping for the best.
Scope of Work
- Low voltage installations for new construction
- Tenant improvement and remodel wiring
- Security system and network infrastructure installs
- Projects of any complexity, quoted straight
Where This Applies
How The Work Runs
Scope and walk
We confirm the scope on site, review drawings where they exist, and flag conflicts before they turn into change orders.
Rough-in
Pathways, boxes, and cable runs placed to coordinate with the other trades and the schedule they are working to.
Trim and terminate
Devices mounted, terminations made, systems configured and tested against the scope that was quoted.
Closeout
Labeling and documentation finished, systems demonstrated to you, and the site left clean.
Common Questions
Is there a job too small?
No. Single-device installs are normal work here. A one-camera job gets the same licensed contractor and the same standard as a full buildout.
Can you coordinate with our general contractor and the other trades?
Yes. Rough-in timing, pathway coordination, and inspection schedules are part of the job on new construction and tenant improvement work.
Do you work in buildings that are still occupied?
Regularly. Work gets sequenced and cleaned up around your operation so the building stays usable while the install moves forward.